LG Electronics DR787T owner manual Connections to your TV

Connections to your TV

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the ANTENNA OUT jack on the Recorder to the antenna in jack on the TV using the supplied 75- ohm Coaxial Cable (R).

How to set the Recorder’s RF output channel

1.When the Recorder is turned off, press and hold CH (V/v) on the front panel for more than five seconds. [ch 03] or [ch 04] appears in the display window.

2.Press CH (V/v) to change the RF output channel (ch 03 or ch 04).

3.Tune the TV to this channel.

Video connection

Connect the VIDEO OUTPUT jack on the Recorder to the video in jack on the TV using the video cable supplied (V).

Note:

If you use this connection, set the TV’s source selector to

VIDEO.

S-Video connection

Connect the S-VIDEO OUTPUT jack on the Recorder to the S-Video in jack on the TV using the optional S-Video cable (S).

Component Video connection

If your television is a high-definition or “digital ready” television, you may take advantage of the Recorder’s progressive scan output for the highest video resolu- tion possible.

Connect the COMPONENT OUTPUT jacks on the Recorder to the corresponding in jacks on the TV using an optional Y PB PR cable (C).

Notes:

•Set the resolution to 480p using RES. button on the front panel for progressive signal.

•Progressive Scan does not work with the RF, Video or S-Video connections.

•If your TV does not accept the Progressive Scan format, the picture will appear scrambled.

•If the resolution is set to 720p or 1080i, the VIDEO OUTPUT, S-VIDEO OUTPUT and COMPONENT OUT- PUT connections are not available.

Audio connection

Connect the Left and Right AUDIO OUTPUT jacks on the Recorder to the audio left/right in jacks on the TV using the supplied audio cables (A1 or A2).

Rear of TV

S-VIDEO	COMPONENT/PROGRESSIVE SCAN			AUDIO INPUT
INPUT		VIDEO INPUT
	Pr	Pb	Y	R	L

S C A2

Rear of Recorder

R V A1

Rear of TV

14