Operation
8. Forced Operation
Operation procedures when the remote control can't be used.
The operation will be started if the power button is pressed.
If you want to stop operation,
|
|
|
| ON/OFF |
|
|
|
|
| button |
|
|
|
|
|
|
|
|
| Cooling |
| Heat pump Model |
|
|
|
|
|
|
|
|
| Model | Room Temp. ≥ 76°F(24°C) | 70°F(21°C) ≤ Room Temp. < 76°F(24°C) | Room Temp. < 70°F(21°C) |
|
|
|
|
|
|
| Operating mode | Cooling | Cooling | Healthy Dehumidification | Heating |
|
|
|
|
|
|
| Indoor FAN Speed | High | High | Healthy Dehumidification Rule | High |
|
|
|
|
|
|
| Setting Temperature | 72°F(22°C) | 72°F(22°C) | 74°F(23°C) | 76°F(24°C) |
|
|
|
|
|
|
Test operation |
|
|
|
| |
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room tempera- ture and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1 "beep".
If you want to stop the operation,
9. Auto restart
In case the power comes on again after a power failure, Auto Restarting Operation is the function to operate procedures automatically to the previous operating conditions.
So there is no need of activating this function by pressing any key or button.
In the initial mode, the fan operates at a low speed and the compressor starts 2.5~3 minutes later. As the compressor starts, the fan speed also resumes its previous setting mode.
High Speed
Helpful information
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the value when the fan speed is set to high, and the capacity will be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the room quickly.
NOTICE
Auto restart function has set enable as factory default.
But customer can set up by following this instruction.
To be disable function
- Press and hold the ON/OFF button for 6 seconds, then the buzzer sound 2 "beep" and the indicator lamp (1) blinks 4 times.
To be enable function
-Press and hold the ON/OFF button for 6 seconds, then the buzzer sound 2 "beep" and the indicator lamp (1) brights 4 times.
42Room Air Conditioner
