Installation
To make it possible to fasten the refrigerator panel at the bottom the
5.Grasp the
The soft-stop cylinder retracts in the detached state.
7.Dismantle the lower attachment bracket from the refrigerator door. Align the bracket to the lines on the refrigerator door panel. (Figure 28).
Fasten the bracket with any hole wherever possible using a minimum of 6 screws 4 x 16 mm.
Figure 28
Figure 26
6.Transfer the lower edge of the attachment bracket onto the panel using a pencil. (Figure 27). Remove the panel from the refrigerator door.
Figure 27
8.Open the refrigerator door and hang the panel on the adjusting bolts (Figure 29).
9.Screw on the hex nuts to the adjusting bolts and finger tighten temporarily (Figure 29).
Figure 29
15
