Installation
Leveling the Appliance - Figure 18
1.Adjust the height of the appliance at the front by twisting
the leveling feet 1 (A/F 27). Use the
2. Adjust the height of the appliance at the rear by turning the adjusting bolts 2.
3. Rotate leveling feet
1until firmly inFigure 18 place against the floor.
To prevent the appliance from tipping forward the leveling feet 1(Figure 19) must have contact with the floor.
Fasten the appliance in the recess
Fasten the appliance in the recess through the upper and lower hinges of the refrigerator doors. Use 2 screws for each hinge.
screws
(4 x 16 mm)
Figure 20
Adjusting the front of the drawer
- Figure 19
If required, the front of the freezer drawers can be adjusted.
Transfer the screws shown in the illustration (on the left and right sides of the freezer drawer) individu- ally to the long slots below.
Tighten the screws in the front of the drawer once it is in the right position.
Side view of the freezer drawer pulled out
Figure 19
Before mounting the door panels
- Figure 21
Remove cover 1 and unscrew the upper attachment bracket 2 of both refrigerator doors. These brackets will be mounted onto the refrigerator door panels.
iMPORTANT
The nuts are needed to fit the premounted panels onto the refrigerator doors.
Figure 21
12
