Liebherr HCB 2062 Blocking for Safety, Mounting the anti tipping device on wooden floors, Wall

- Figure 9

Blocking for Safety

Mounting the anti tipping device on concrete floors - Figure 7 - 8

Secure the appliance in place so it does not tip forward when the fully stocked door is opened. The anti tipping bracket is provided with the appliance.

1. Mark the center line of the appliance on the back	Wall
wall. Align the anti tipping bracket center to this
line.
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Drill a 3/8" diameter hole in any position as	Wall Plate
shown in Figure 7 using a carbide drill bit.
The depth of the holes must exceed the overall
length of the anchors provided.
Clean the holes after drilling.	Wall

3.Attach washer and screw on hex nut to the end of each anchor.

Drive in all 3 anchors.

Align the bracket center to the center line on the back wall again.

Fasten the anchors by turning the hex nut.

4. Fasten bracket with 3 screws (1/4" x 2-1/8") into
the wall plate (Figure 8).	Wall Plate

Mounting the anti tipping device on wooden floors

1.Mark the center line of the appliance on the back wall. Align the anti tipping bracket center to this line.

Be sure that there is no plumbing or	Wall
electrical wiring located in this area which
screws or drills could damage.
2. Fasten bracket to the wooden floor using
5 screws (1/4" x 2-1/8"). Drill pilot holes if neces-
sary.

3. Fasten bracket with 3 screws (1/4" x 2-1/8") into the wall plate.

Wall Plate

Figure 7

Figure 8

Figure 9

8