IceMaker
4.Push the appliance slowly to the back wall until the compressor mounting plate makes contact with the
To prevent the appliance from tipping forward the compressor mounting plate must have contact with the anti tipping bracket (Figure 15).
Wall
Appliance
Anti - tipping bracket
Compressor mounting 
plate
Figure 15
5.Remove the cover from the valve connector (Figure 16).
6.The water line is visible at the front of the aplliance. Connect the water line with the OD adapter (Figure 16).
7.Bleed the air from the water line by opening the water supply temporarily.
8.Screw the OD adapter onto the solenoid valve (Figure 17).
Figure 16
Figure 17
9.Open the
IMPORTANT
After starting up the appliance, the water pipe system must be purged of any air. Refer
to chapter "Bleeding the ice maker" in the operating instructions.
11
