Installation
Mounting the freezer drawer
panels - Figure 23
1.Pull out the upper freezer drawer and screw on the panel with three screws at left and right hand side using the screws as shown in Figure 23.
2.Close the drawer and check the position to the surrounding cabinet panels. Align the panel in vertical direction by loosening the screws left and right. Finally tighten the screws.
Do not overtighten. Do not use a power driver.
3.Pull out the lower freezer drawer and fasten the lower panel in the same way.
4.Finally cover the gap between the drawer and the panel of both freezer drawers with the strips provided. Remove the foil from the adhesive surface of the strip and stick on the top of the appliance drawer (Figure 23) making sure the flexible gasket is fully inserted in the gap.
Screw 3.5 x 13 mm
Figure 23
Mounting the refrigerator door
panels - Figures 24 - 33
The description is for one panel only. The procedure is the same for both panels.
1.Open the refrigerator door and hang the panel on the adjusting bolts (Figure 24).
2.Screw on the hex nuts to the adjusting bolts and finger tighten temporarily (Figure 24).
Figure 24
3.Close the door and check the height of the panel.
4.Align the panel in its vertical position if necessary. Loosen the hex nuts and turn the adusting bolts using a screwdriver for slotted screws (Figure 25).
Figure 25
14
