LightSpeed Technologies LES 600 Series DC Power Connector, 14 & 15 Transmitter Charging Jacks

16 L E S 6 0 0 O P E R A T I N G I N S T R U C T I O N S

		EQ	23
22		Hi
			24
21		Mid
	Mic 2		Mic 1
	Antenna	Low	Antenna
20
19	Aux 1	Aux 2
	Input	Input
			25

18Output 1

17	Mixed	Level Adjust	Speaker	Speaker
			Zone	Ouputs
	Audio

Switch

16Output 2

			1	26
15	Level Adjust
		F1	2	27
	Transmitter
14	Charging	F2	3
				28
		F3
13			4
	DC Power In			29

30

13DC Power Connector:

The Receiver/Amplifier requires a 15-volt, 2.4 Amp DC power supply. The center conductor is positive (+) polarity.

Caution: Power supplies from different manufacturers have various output voltages, current ratings, and polarity. Connecting the wrong type of power supply can result in damage to the LES 600.

14 & 15 Transmitter Charging Jacks:

This is used to charge the rechargeable NiMH batteries in the belt-pack Transmitter and optional Hand-held Microphone. One end of the charging cable is connected to this jack. The other end of the charging cable is connected to the BATTERY CHARGING INPUT located on the side of the belt-pack Transmitter, or bottom of the Hand-held Microphone.

See previous diagrams on page 5 and 8.

16 & 18 Mixed Audio Output Level Adjust:

Rotating the MIXED AUDIO OUTPUT ADJUST clockwise increases the level of the audio signal at the Mixed Audio Output jack located on the back panel.

17 & 19 Mixed Audio Output Jack:

The Mixed Audio Output jack sends to an external source, the same audio information that is being supplied to the speaker system. For example, this output could be used to connect to a tape recorder for recording purposes, or to an assistive listening device such as LightSPEED’s LES-360 FM Personal Listening System.