Linksys FENSK05 v2 manual

Linksys EtherFast® Series

6.When NT asks you for the media type. Choose the AutoSense option. When finished, click on OK. Click Close.

10/100 Network In a Box

10. Remove your Driver Disk and CD-ROM and click Yes to restart your PC.

7.NT will probably ask you to supply your original Windows NT CD-ROM or setup disks. Direct Windows NT to the proper location (most likely

D:\i386).

Note: If you install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation when installation steps that aren’t listed in this User Guide appear. Linksys does not provide technical support for the configura- tion or troubleshooting of the TCP/IP protocol.

11.Once your PC has rebooted, double-click the Network Neighborhood icon on your desktop. Ensure that you have access to the network. If you do, your card has been properly installed.

•If you had previously installed any NT service packs, you must re-install them. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer.

•If you need to install the TCP/IP protocol, refer to your system adminis- trator or your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol

The Windows NT Installation and Setup of the EtherFast 10/100 LAN

Card is complete.

8.Click on the Protocols tab. Add any protocols you require by clicking the Add button. (Refer to your Microsoft documentation if you have any ques- tions on adding protocols.)

9.After your bindings, settings, and services are set, click the Close button.

Note: If you had previously installed any NT service packs, you must re-install them. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer.

38 39