Linksys FENSK05 v2 manual

Linksys EtherFast® Series

10/100 Network In a Box

11.NT will copy the necessary network drivers to your PC. When the copying is complete, you will see a list of installed bindings. Change the bindings settings if needed and click Next. Click Next again.

Note: For information and help on choosing your bindings, services and protocols, ask your network administrator, or check your Windows NT documentation.

13.Click Finish. When asked if you want to restart your computer, remove the Driver Disk and click Yes.

14.Once your PC has rebooted and you are logged in, double-click the Network Neighborhood icon on your desktop. Ensure that you have access to the network. If you do, your card has been properly installed.

•If you had previously installed any NT service packs, you must go back and re-install those service packs now.

•If you need to install the TCP/IP protocol, refer to your system adminis- trator or your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol

12.Choose either Workgroup or Domain, depending on the type of network you're setting up. (Your Microsoft documentation explains the difference between Workgroups and Domains.) Click Next.

The Windows NT Installation and Setup of the EtherFast 10/100 LAN Card is complete. Do not continue on with the next set of instructions. They are for NT users who already had their networking configured.

Note: If you had previously installed any NT service packs, you must re-install them. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer.

34 35