Placement Options, Stand Option | Linksys PAP2-VU specification

Phone Adapter with 2 Ports for Voice-over-IP

Placement Options

There are three ways to place the Phone Adapter. The first way is to place the Phone Adapter horizontally on a surface. The second way is to stand the Phone Adapter vertically on a surface. The third way is to mount the Phone Adapter on a wall. The second and third options are explained in further detail below.

Stand Option

1.Remove the plate from the Phone Adapter’s bottom panel.

2.Line up the pegs of the Phone Adapter’s base with the mounting holes of the Phone Adapter’s bottom panel.

3.Insert the Phone Adapter’s base into the Phone Adapter’s bottom panel. Push the base in until it fits snugly.

4.Place the Phone Adapter in an appropriate location.

Congratulations! The installation of the Phone Adapter is complete.

If you need to change any of the Phone Adapter’s network settings, proceed to “Chapter 4: Using the

Phone Adapter’s Interactive Voice Response Menu.”

Figure 3-5: Attaching the Phone

Adapter’s Base

Figure 3-6: Phone Adapter Standing

on Base

Chapter 3: Connecting the Phone Adapter

7

Placement Options

Image 12

Linksys PAP2-VU manual Placement Options, Stand Option, Remove the plate from the Phone Adapter’s bottom panel

Contents

Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and Trademarks Table of Contents Back Panel Front Panel Introduction WelcomeWhat’s in this Guide? What’s in this Guide? Getting to Know the Phone Adapter Back Panel Ports Front Panel Phone Adapter’s LEDs are located on the front panelPhone is being used or an incoming call has been detected Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview Internet Connect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Wall-Mount Option Measurement between Wall-Mount Slots Using the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exit Has been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100 Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal point Address Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and Solutions Appendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally would Can I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions Storage HumidityMm x 101 mm x 15 mm Appendix E Warranty Information Limited Warranty Appendix E Warranty Information Appendix F Regulatory Information FCC Statement Appendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information