Check Dhcp 100, Has been enabled or disabled. If | Linksys PAP2-VU

Phone Adapter with 2 Ports for Voice-over-IP

Interactive Voice Response Menu

Action	Command	Choices	Description
	(press these
	keys on the
	telephone)

Check DHCP	100		Use this command to find out if DHCP
			has been enabled or disabled. If
			enabled, the Phone Adapter will be
			automatically assigned an IP address
			by your network router or gateway. If
			disabled, then the Phone Adapter will
			use a static IP address.

Enable/Disable DHCP	101	Enter 1 to enable	Enable or disable the Phone Adapter’s
		Enter 0 to disable	DHCP feature. If your network router
			or gateway assigns IP addresses, then
			enter 1. Otherwise, enter 0.

Check IP Address	110		You will hear the current IP address of
			the Phone Adapter.

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

11

Using the Interactive Voice Response Menu

Image 16

Linksys PAP2-VU manual Check Dhcp 100, Has been enabled or disabled. If, Use a static IP address, Enter 1 to enable

Contents

Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and Trademarks Table of Contents Back Panel Front Panel Welcome IntroductionWhat’s in this Guide? What’s in this Guide? Getting to Know the Phone Adapter Back Panel Ports Phone Adapter’s LEDs are located on the front panel Front PanelPhone is being used or an incoming call has been detected Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview Internet Connect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Wall-Mount Option Measurement between Wall-Mount Slots Accessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exit Has been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100 Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal point Address Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and Solutions Appendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally would Can I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity DimensionsMm x 101 mm x 15 mm Appendix E Warranty Information Limited Warranty Appendix E Warranty Information Appendix F Regulatory Information FCC Statement Appendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information