Linksys PAP2-VU specification

Phone Adapter with 2 Ports for Voice-over-IP

8. Repeat steps 5-7 until you have entered all four port ranges for the Phone Adapter.

Application	Start and End	Protocol	IP Address	Enable

Internet phone 1	5060 to 5061	UDP	(IP address of	X
			Phone Adapter)

Internet phone 2	53 to 53	UDP	(IP address of	X
			Phone Adapter)

Internet phone 3	69 to 69	UDP	(IP address of	X
			Phone Adapter)

Internet phone 4	10000 to 20000	UDP	(IP address of	X
			Phone Adapter)

9.Check the Enable option for the port services you want to use.

10.When you have completed the configuration, click the Save Settings button.

5.The Power LED does not light up or lights up red. Go through this checklist until your problem is solved:

•Unplug the power adapter from the Phone Adapter. Wait five seconds. Then plug the power adapter into the Phone Adapter again.

•You may be using the wrong power adapter. Make sure the power adapter you are using is the one included with the Phone Adapter.

22	Appendix A: Troubleshooting
	Common Problems and Solutions

Image 27

Linksys PAP2-VU manual Application Start and End Protocol IP Address Enable

Contents

Division of Cisco Systems, Inc Phone AdapterPage Copyright and Trademarks How to Use this Guide Table of Contents Front Panel Back Panel Introduction WelcomeWhat’s in this Guide? What’s in this Guide? Back Panel Ports Getting to Know the Phone Adapter Front Panel Phone Adapter’s LEDs are located on the front panelPhone is being used or an incoming call has been detected Internet Connecting the Phone AdapterInstructions for Connecting the Phone Adapter Overview Connect the Telephone Cable Phone Adapter’s Interactive Voice Response Menu Placement OptionsStand Option Remove the plate from the Phone Adapter’s bottom panel Measurement between Wall-Mount Slots Wall-Mount Option Using the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Key or hang up to exit Use this command to enter Response MenuInteractive Voice Response Menu Not press any other keys until you Check Dhcp 100 Has been enabled or disabled. If101 Enter 1 to enable Enter 0 to disable Network mask When entering a Decimal point Address usingStatic IP address When entering a Decimal point Subnet Mask Mask using 131 Enter the IP Address Address usingStatic gateway IP address When entering a Decimal point Phone Adapter Manual Reboot 732668 Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a Troubleshooting Appendix a Troubleshooting IP address Phone Adapter Internet phone 69 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 53 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Pick up the phone and dial as you normally would Frequently Asked Questions Can I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions Storage HumidityMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty Information Appendix E Warranty Information FCC Statement Appendix F Regulatory Information Appendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information