Chapter 4 | Configuration Using the |
Port Management > LACP
In addition to LAGs that you create by manually grouping ports together, you can also use the Link Aggregation Control Protocol (LACP) to automatically negotiate a LAG link between the Switch and another network device.
The LACP screen contains fields for configuring LACP LAGs. This screen is divided into three parts: Global Parameter, Port Priority, and LACP Port Table.
Port Management > LACP
Global Parameter
LACP System Priority The global LACP priority value, from 1 to 65535. The default value is 1.
Port Priority
Port The port number to which the timeout and priority values are assigned. To configure a different port, select it from the
LACP Port Priority Defines the LACP priority value for the port, from 1 to 65535. The default value is 1.
LACP Timeout The administrative LACP timeout value. Select either Short or Long (default).
Admin Key
When you are finished entering the settings above, click Update to apply the settings.
LACP Port Table
This section provides a
After you are finished setting the LACP parameters, click Save Settings to save the settings, or click Cancel Changes to cancel your changes.
Port Management > PoE Power Settings
NOTE: This section applies ONLY to the SLM224P and SLM248P Smart Switches.
The PoE Power Settings screen allows you to configure the Power over Ethernet (PoE) ports on the Switch.
Port Management > PoE Power Settings
Port Displays the port number.
Admin Status Check the checkbox to enable PoE power to be supplied to the connected device.
Priority Select Critical, High, or Low (default) from the drop‑down menu to set the priority of the port.
Power Allocation (milliwatts) Sets the maximum power in milliwatts that can be supplied to the port.
Power Consumption (milliwatts) Displays the power currently being used by the connected PoE device.
Click Save Settings to save the changes, or click Cancel Changes to cancel your changes.
Business Series Smart Gigabit Ethernet Switch | 17 |
