Linksys SLM248G, SLM248P, SLM224P manual Chapter Product Overview, SLM2048, Back Panel, Front Panel

Chapter 2

Chapter 2:

Product Overview

SLM2048

Front Panel

The Switch’s LEDs and ports are located on the front panel.

Front Panel of the SLM2048

SYSTEM  (Green)  Lights up to indicate that the Switch is powered on. Blinks while the Switch is performing a system self-test.

LNK/ACT (1-48) (Green) Lights up to indicate a functional 10/100/1000 Mbps network link through the corresponding port (1 through 48) with an attached device. Blinks to indicate that the Switch is actively sending or receiving data over that port.

Gigabit (1-48) (Amber) Lights up to indicate a functional 1000 Mbps connection on the corresponding port (1 through 48) with an attached device.

Reset  Press and hold the Reset Button for less than ten seconds to reboot the Switch. Press and hold the Reset Button for more than ten seconds to reset the Switch’s settings to the factory defaults.

Ethernet 1-48 The Switch is equipped with 48 auto-sensing, Ethernet network ports, which use RJ-45 connectors. The Fast Ethernet ports support network speeds of 10 Mbps, 100 Mbps, or 1000 Mbps. They can operate in half- and full- duplex modes. Auto-sensing technology enables each port to automatically detect the speed of the device connected to it (10 Mbps, 100 Mbps, or 1000 Mbps), and adjust its speed and duplex accordingly.

Product Overview

miniGBIC (1-2) The miniGBIC (gigabit interface converter) port is a connection point for a miniGBIC expansion module, so the Switch can be uplinked via fiber to another switch. The MiniGBIC port provides a link to a high-speed network segment or individual workstation at speeds of up to 1000 Mbps.

To establish a Gigabit Ethernet connection using a miniGBIC port, you will need to install a MGBT1, MGBSX1, or MGBLH1 Gigabit expansion module and use Category 5e cabling or fiber optic cabling.

To establish a Fast Ethernet connection using a miniGBIC port, you will need to install a MFEFX1 (100BASE-FX) or MFELX1 (100BASE-LX) 100SFP Transceiver and use fiber optic cabling.

NOTE:  On the SLM2048, MiniGBIC ports are shared with standard ports. If a miniGBIC port is used, then the shared standard port on the Switch cannot be used. The following table defines the shared port mapping of the SLM2048 Switch.

SLM2048 Shared Port Mapping

miniGBIC Port	Standard Port
miniGBIC 1	Port 24
miniGBIC 2	Port 48

Back Panel

The power port is located on the back panel of the Switch.

Back Panel of the SLM2048

POWER  The Power port is where you connect the AC power.

Business Series Smart Gigabit Ethernet Switch