Stove Installation (for qualified installers only) | 15 |
Mobile Home Requirements
•Outside air must be installed - see "Outside Air Requirements" on page 13
•Chimney connector and chimney must be one of the following types:
DURAVENT model DVL connector with DURAVENT UL 103 HT chimney
GSW Super Chimney
I.C.C. Excel HP connector with I.C.C. UL 103 HT chimney
METALFAB model DW connector with METALFAB UL 103 HT chimney
OLIVER MACLEOD PROVENT model PV connector with OLIVER MACLEOD UL 103 HT chimney
SECURITY model DP connector with SECURITY UL 103 HT chimney
SELKIRK model DSP connector with SELKIRK UL 103 HT chimney
Standard Masonry Chimney with any one of the above listed connectors
NOTE: Reduced clearance connectors may not connect to the flue collar – an appliance adapter may be required.
•Stove placement must maintain the following clearances to combustibles (drywall, furniture, etc.)
D
A
EC B
F
C
Measure clearances from the nearest edge of the stove top.
Minimum Clearance | Reduced Clearance | |
(See the illustration above) | Connector | |
|
|
|
A | Sidewall to stove | 18.00” |
B | Backwall to stove | 20.75” |
C | Cornerwall to stove | 14.00” |
D | Connector to sidewall | 28.25” |
E | Connector to backwall | 14.00” |
F | Connector to cornerwall | 17.50” |
• If using offsets, use the connector clearance listed in Figure 12, not the connector manufacturer's clearance.
•The appliance must be secured to the floor (consult your
building official). Secure the outside air boot to the floor and stove to insure the stove does not dislocate.
•Mobile home installations require a spark arrester at the chimney termination.
•The appliance must be grounded to the chassis of the mobile
home (consult your building official).
• WARNING:DO NOT INSTALL IN SLEEPING ROOM.
• CAUTION:THE STRUCTURAL INTEGRITY OF THE MOBILE
HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.
Figure 11
12” Min.
Connector Clearance (as outlined above)
Stove Clearance (as outlined
Figure 12
© Travis Industries | 4060802 |
