36 | Optional Equipment |
Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating instructions are described in the section "Blower Operation".
a
c
Bend the legs of the
thermodisk bracket to make it
b
Tuck the thermodisk into place. It wedges between the rear heat sheild and the cast iron firebox.
Route the wires on the outside of the stove, behind the convection jacket.
d
Route the wires from the blower through the hole in the back of the blower housing. Attach these wires to the thermodisk wires.
3/8" Wrench
f
Attach the blower to the stove with the three screws included with the blower.
e
Position the blower near the rear of the stove. Tuck all excess wire into the blower box, making sure it does not contact any moving parts. Make sure when installing the blower, these wires do not become loose.
g Plug the blower in. Do not route the power cord under or over the stove or in a location where it may become damaged.
© Travis Industries | 4060802 |
