LOREX Technology LH1361001C8B, LH130 Accessing your DVR within a local network LAN, Internet

Setting up your DVR for Remote Connectivity

Accessing your DVR within a local network (LAN)

You can connect to your DVR through Internet Explorer through the local area network (LAN). It is recommended to confirm connectivity over a local network before setting up your DVR for Internet connectivity.

NOTE: To complete the steps below, your computer must be on the same network as your DVR.

NOTE: Except where noted, the instructions below are the same for PC and Mac.

Step 1 of 3: Connect your DVR to the Local Area Network

1Power off your DVR by turning the power switch to .

2Connect an Ethernet cable (included) to the LAN port on the rear panel of the DVR. Connect the other end of the Ethernet cable to an empty LAN port (usually numbered 1~4) on your router.

3Turn the power switch to I to power the DVR back on.

8-channel model shown

Ethernet Cable (included)

INTERNET

(not required for local viewing)

ROUTER	COMPUTER
(Not Included)
	(Not Included)

Step 2 of 3: Obtain the DVR’s Local IP Address and HTTP Port

1Press the PTZ/ button on the front panel of the DVR to open the System Information window.

DVR IP address

HTTP Port

52