LOREX Technology LH130, LH1361001C8B Adjusting Menu Transparency, Adjusting the Video Margin

Using the Main Menu

restarts. The DVR will restart with the default resolution of 1024 x 768.

Stop button ()

3When the DVR restarts, click Yes to confirm the default resolution.

NOTE: If your system resolution is already in 1024 x 768, pressing and holding the Stop button will not restart the system.

Adjusting Menu Transparency

You can increase or decrease the transparency of the on-screen menus.

To adjust the transparency of on-screen menus:

1Click the Output tab.

2Drag the Transparency slider to adjust transparency.

3Click Apply to save your settings.

Adjusting the Video Margin

If you connect your DVR to a BNC monitor, you can adjust the video margins.

NOTE: On the 16-channel model, you must select the BNC output mode to adjust the margins. Press 0 three times on the remote control to switch the output mode between BNC mode and VGA/HDMI mode. When BNC mode is selected, the mouse cursor appears on the BNC monitor.

To adjust the video margin:

1Click the Output tab.

2Click the Margin button.

3Drag the sliders to the left or right to adjust the Left, Right, Top, or Bottom Margin.

4Click Apply to save your settings and click OK to confirm.

Adding Privacy Zones

A privacy zone allows you to block out up to 4 portions of each channel with a black square.

ATTENTION: Areas covered by privacy zones are not visible in recordings.

To configure a privacy zone:

1Click the Privacy Zone tab.

2In the Channel drop-down menu, select the channel you wish to configure.

Privacy Zone

3Configure the following:

•Channel: Select the channel you wish to configure.

35