Operation | Lucent Technologies 954 guide

OPERATION

	Displays the
	elapsed call	Prevents
	time in minutes	Prevents
	time in minutes	interruptions
	and seconds	interruptions
	and seconds	during a call
		during a call
	Automatically
	redials a
	number when
	the line you’re
	calling is busy	Activate custom-
		calling services
	Redirect an	Redial last
	incoming call	number called
	to any other
	954 phone
	Line-in-use
	lights

Put a caller on hold

Mute the microphone

Activate speakerphone

Adjust Ringer and Handset/Speakerphone volume

12

Lucent 0954 book.L1

12

5/7/98, 10:35 AM

Image 14

Lucent Technologies 954 user manual Operation

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephone Check for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tab Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the Clock Set for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer Off Auto Redial Switch Between LinesRedial Hold Temporary Tone Dialing MuteFlash Conference Calls Transferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced Call Timer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory Number Intercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call or Making an Intercom Conference Call Paging All PhonesAnswering an Allpage Room Monitor Case of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant Station Attendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page