Before YOU Begin | Lucent Technologies 954 manual

BEFORE YOU BEGIN

•You must have a modular telephone jack and electrical outlet near where you’re installing the phone.

•The total length of telephone line cord used in this system is important. If the total length of telephone line cord is more than 600 feet, you may need to use a special filter device. You can call 1 800 PCC–9125 for information about this filter. You’ll need to contact a professional to install this filter.

•Identify the number of phone lines you’ll use.

•All connected phones must have the same Line 1 phone number for Intercom and Paging to work.

•Assign a different Intercom Extension Number (11 through 22) to each 954 telephone. You’ll need to do this individually at each telephone.

•Decide if you want a private line. A private line does not appear on all connected phones.

3

Lucent 0954 book.L1

3

5/7/98, 10:34 AM

Image 5

Lucent Technologies 954 user manual Before YOU Begin

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephone Check for dial tone Connect the power adapterConnect the handset cord Reverse the handset tab Wall Installation Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the Clock Set for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer Off Redial Switch Between LinesAuto Redial Hold Flash MuteTemporary Tone Dialing Conference Calls Transfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced Call Timer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory Number Intercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call or Answering an Allpage Paging All PhonesMaking an Intercom Conference Call Room Monitor Case of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant Station Attendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page