Connect the power adapter | Lucent Technologies 954 specification

INSTALLATION

•Two Two-Line Jacks

Modular

Telephone Jack

Lines 3 and 4

Modular

Telephone Jack

Lines 1 and 2

Telephone Jacks

Standard

Electrical

Outlet

Telephone	Power Cord
Line Cords

3Connect the power adapter.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 PCC–9125.

Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone. Plug the other end into a standard electrical outlet.

4Connect the handset cord.

Plug one end of the coiled handset cord into the jack on the bottom of the phone. Plug the other end into the handset, and hang up.

5Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY in this manual.

5

Lucent 0954 book.L1

5

5/7/98, 10:34 AM

Image 7

Lucent Technologies 954 user manual Connect the power adapter, Connect the handset cord, Check for dial tone

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteries Connect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall Installation Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom Number Change Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer Volume Hold Switch Between LinesRedial Auto Redial Conference Calls MuteFlash Temporary Tone Dialing Transferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced Call Timer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in Memory Intercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call or Room Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference Call Case of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power Failure Expanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex Operation Answering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page