Table/Desk Installation | Lucent Technologies 954 instruction

INSTALLATION

Table/Desk Installation

1Install 3 AAA batteries.

•Press in on the tabs and remove the telephone base.

•Press in on the tabs on the battery door, and remove it.

•Insert 3 AAA batteries, and replace the battery door.

•Replace the telephone base.

NOTE: Batteries retain telephone memory in the event of a power failure. If power fails, this phone will not work.

2 Connect the telephone line cords to the telephone.

NOTE: If the phone rings when you first connect the line cords, you need to set the phone’s intercom number. See “Assign Intercom Number” in the TELEPHONE FEATURE SETUP section of this manual.

•Four One-Line Jacks

Modular

Telephone Jacks

Lines 3 and 4

Modular

Telephone Jacks

Lines 1 and 2

Standard

Electrical

Outlet

Telephone Jacks

Telephone	Power Cord
Line Cords

4

Lucent 0954 book.L1

4

5/7/98, 10:34 AM

Image 6

Lucent Technologies 954 user manual Table/Desk Installation, Install 3 AAA batteries

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephone Connect the power adapter Connect the handset cordCheck for dial tone Wall Installation Reverse the handset tab Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the Clock Set Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer Off Auto Redial Switch Between LinesRedial Hold Temporary Tone Dialing MuteFlash Conference Calls Transferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced Call Timer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory Number Intercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call or Making an Intercom Conference Call Paging All PhonesAnswering an Allpage Room Monitor Case of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant Station Setting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page