Telephone Memory | Lucent Technologies 954 instruction

TELEPHONE MEMORY

One-touch memory locations

Store the switchhook flash needed to access some custom-calling services

Directory Card

Access two-touch memory locations

Store a pause in a memory number

Store a tone signal in a memory number

This telephone has 18 one-touch memory locations, and 18 two-touch memory locations. Each location can store up to 16 digits. Dial numbers stored in one-touch locations by lifting the handset (or pressing speaker) and pressing the button for the location. Dial numbers stored in two-touch locations by pressing land the button for the location.

19

Lucent 0954 book.L1

19

5/7/98, 10:35 AM

Image 21

Lucent Technologies 954 user manual Telephone Memory

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephone Connect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall Installation Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the Clock Set Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer Off Redial Switch Between LinesAuto Redial Hold Flash MuteTemporary Tone Dialing Conference Calls Transfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced Call Timer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory Number Intercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call or Answering an Allpage Paging All PhonesMaking an Intercom Conference Call Room Monitor Case of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant Station Setting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page