Wall Installation | Lucent Technologies 954 specs

INSTALLATION

Wall Installation

1Reverse the handset tab.

Hold down the switchhook, then pull the tab out and rotate it 180 degrees. Release the tab so it settles into position.

2Install 3 AAA batteries.

•Press in on the tabs and remove the telephone base.

•Press in on the tabs on the battery door, and remove it.

•Insert 3 AAA batteries, and replace the battery door.

3Turn the base, as shown, and attach it to the bottom of the phone.

6

Lucent 0954 book.L1

6

5/7/98, 10:34 AM

Image 8

Lucent Technologies 954 user manual Wall Installation, Reverse the handset tab

Contents

User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephone Check for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tab Connect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the Clock Set for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer Off Switch Between Lines RedialAuto Redial Hold Mute FlashTemporary Tone Dialing Conference Calls Do Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced Call Timer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory Number Intercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call or Paging All Phones Answering an AllpageMaking an Intercom Conference Call Room Monitor Case of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SET Expanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant Station Attendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page