HD24/96 Technical Reference

41

button, and you can use the RECORD button to punch in and out anywhere within the Punch region.

Automatic punching can only be set up, enabled, and disabled from the GUI or the remote controllers. Once the punch-in and -out points are set, you can use either the front panel, GUI, or remote controllers to control recording in the Punch mode. Punch must be disengaged in order to manually control recording operations outside of the Punch area.

Auto Take

Auto Take automatically increments the Active Take of the selected track when recording multiple passes on the same track. Auto Take will increment all tracks that are enabled for recording. Auto Take mode is often used in conjunction with looping and Auto Punch for convenient repeated recording of alternate takes of a section.

NOTE: The Active Take is incremented when the next recording pass begins, not at the end of the current recording pass.

Take 8 on any given track is the end of the line for the Auto-take function. If you don’t stop recording after Take 8, you will continue to record over the last take rather than wrap around and start back at Take 1. You knew the first take was the best one anyway.

Record Time Left

This readout displays the remaining recording time in hours, minutes, and seconds available on the active disk drive. This lets you know if there’s enough remaining disk space for your next take. On the GUI, it’s located in the upper left corner of the Tools panel. On the front panel, it’s the last line of the top level display in the LCD (you may have to press a button to wake-up the LCD).

The calculation of available recording time takes into account the sample rate and bit depth as well as the number of tracks currently armed for recording. With no tracks armed, the time is calculated for the worst case, as if your next record pass will be on all 24 tracks. Once a track is armed, the available time displayed changes, dividing the total amount of free drive space by the number of tracks armed.

Try it. Look at the time with no tracks armed, then arm one track and you’ll see the available time increase dramatically. Now, arm a second track and you’ll see that the time has been cut in half. Arm two more tracks and it’ll cut in half again. You’ll get the idea.

Monitor Modes

The all important record monitor function has three operating modes. The HDR24/96 switches its output between playback and the input source as appropriate for the particular task you’re performing – setup, rehearsal, tracking, or punch-ins.

When we say that a track “monitors” input or playback, we’re talking about what comes out the recorder’s output connector. This terminology, as well as monitor input and playback switching, makes a whole lot of sense your console is configured so that you’re always monitoring the recorder’s outputs. The Applications Guide explains this concept in detail.

On the GUI, the All Input and Auto Input monitor mode buttons are located below the track information area, at the lower left corner of the screen. They can also be selected from a pull- down menu under Transport.