HD24/96 Technical Reference

68

 

 

 

 

 

 

times) will snap to cue points on the Marker Bar.

 

 

Snap To Grid

When Snapping is enabled, the various pointers will snap to

 

 

 

discrete points on the Time bar. Resolution of the snap

 

 

 

timesintervals areis set with the Grid Setting option.

 

 

Grid Setting

Selects the resolution of the “snap-to” times when Snap To Grid

 

 

 

and Snapping are active.

 

 

Solo Latch

This is an toggle that selects whether the track Solo (S) buttons

 

 

 

work as “radio” buttons (not latched) or allow multiple selection

 

 

 

(latched). Selecting this item checks (on) or unchecks (off) this

 

 

 

option. When Solo Latch is on, multiple tracks can be selected for

 

 

solo by clicking on their S buttons. When off, the track solo buttons

 

 

allow selection of only one track at a time for solo.

 

 

 

NOTE: Even if Solo Latch is not selected, multiple tracks can be

 

 

 

soloed by Shift-clicking / swiping on the tracks’ S buttons.

 

 

 

 

 

 

Transport

 

 

 

 

 

 

 

Menu Item

What It Does

 

 

 

 

 

 

Chase TC

Functions identically to toggling the CHASE TC button the Tools

 

 

 

panel or pressing the CHASE TC button on the front panel. Sets

 

 

 

the HDR24/96 into the time code chase mode, where it waits for,

 

 

 

locates to, and follows incoming time code.

 

 

Generate MTC

Enables the MTC time code generator function, sending time code

 

 

from the MIDI oOut the enabled SMPTE and/or MIDI connectors.

 

 

 

This function may also be selected from the Setup/Sync menu,

 

 

 

which also provides a similar function for generating SMPTE time

 

 

 

code. See Setup in this table.

 

 

All Input

Selects All Input Monitor mode. Same as toggling the ALL INPUT

 

 

button at the lower left corner of the GUI screen or pressing the

 

 

 

front panel or remote controller ALL INPUT button. See the Monitor

 

 

section of this manual for further details.

 

 

Auto Input

Selects Auto Input Monitor mode. Same as toggling the AUTO

 

 

 

INPUT button at the lower left corner of the GUI screen or pressing

 

 

the front panel or remote controller AUTO INPUT button. See the

 

 

Monitor section of this manual for further details.

 

 

Use Preroll

Adds the amount of Preroll time (set from the

 

 

 

WindowsSetupLocator-MMC menu) to any Locate or Cue Start

 

 

 

point.

 

 

Loop Selection

Allows quick a temporary setting of loop start and end points.

 

 

 

When Loop Selection is enabled, loop points are set to the start and

 

 

end of an I-Beam selected region. With an area selected and Loop

 

 

Selection enabled, when in Play or Record, the transport will loop-

 

 

play over the selected area. The selected area on the time bar

 

 

 

changes to yellow to indicate that looping is engaged.

 

 

 

NOTE: This loop is independent of the loop defined by LOC 1 and

 

 

LOC 2 and that is engaged with the LOOP button. See the Looping

 

 

section of this manual for further details.