Magma 7 Slot Series user manual Step Five Install Software Driver/Verify Installation

M A G M A

There may also be an On/Off switch on the power supply, located in the back of the expansion system. Make sure the power supply switch is in the ‘On’ position before powering up.

When powering up, pay close attention to the eight LEDs on the 64-bit Host Interface and the eight LEDs on the rear panel of the expansion system. All LEDs must be solid green before the system will function properly. If any LED is not solid green, power off the system and check that the RJ45 connectors are seating properly and connected to the correct port before powering up again.

WARNING

The expansion system will not work properly or may not be recognized by the host computer unless all LEDs on the Host Interface and rear panel are solid green.

Ensure that you have connected the cables properly by referring to the diagram in Step Two.

Step Five: Install Software Driver/Verify Installation

NOTE

Only Microsoft Windows XP and Windows 2000 users need to install the 64-bit/66MHz PCI Expansion Driver. All other operating systems should automatically detect the PCI Expansion System and configure properly.

Window XP users, go to page 8.

Windows 2000 users, go to page 11.

Windows ME users, go to page 16.

Mac OS users, go to page 21.

Chapter 2 Installation Guide 7