Magma CB1F manual Step Five Recheck Installation, Step Six Power Sequence, Powering Up

0$*0$

2.Insert the CardBus Host Interface Card with the MAGMA logo side up, (gold strip up) into the PC Card slot. Gently push the card until it is seated firmly.

NOTE

If your computer has two CardBus (or PC Cards) slots, MAGMA recommends that you install the MAGMA CardBus card into Socket 2.

3.For more information on using CardBus PC Cards, please refer to your computer’s user manual or system documentation.

Step Five: Recheck Installation

Check your installation before powering up the 1 Slot CardBus PCI Expansion System for the first time. Although the power supply has an over voltage protection device built into it, it may not "trip" in time to fully protect a device that has been improperly connected or whose power cable has been damaged.

Step Six: Power Sequence

NOTE

If at all possible, plug the power cords from the PCI Expansion System and your host computer into a shared power strip, preferably one that has surge and noise suppression circuitry built into it.

NOTE

The 45 Watt power brick is auto-switching, which means the power brick will automatically adjust to the voltage required for the region you are in.

Powering Up:

￿You must￿6ORWapply6HULHVpower8VHUto ￿theV0DQXDOPCI Expansion System first and then power up your host computer. This will allow the higher numbered PCI buses in your hierarchy to be at a stable state at the time that the host system issues its master power-on bus reset. In systems that perform automatic PCI bus configuration, this will allow the configuration code to recognize the PCI bus hierarchy and the attached devices.