Magma CB1F manual Windows 2000 Instructions

0$*0$

Windows 2000 Instructions

WARNING

You WILL be prompted to Shut Down and Reboot your system several times during software installation. Please be patient, each Shut Down and Reboot does serve a purpose and is required for correct installation. If you Shut Down and Reboot when requested, it may save you from having to make a call to MAGMA Technical Support.

NOTE

Prior to installing the MAGMA CardBus Driver, you should be familiar with the installation procedures for the PCI cards that you are installing in the expansion chassis. Some PCI card manufacturers recommend that you install their software driver(s) prior to installing the hardware. If this is the case, you should install their driver before you connect and power up the expansion chassis. You may be required to reboot before connecting the expansion chassis.

NOTE

Under Windows 2000, you MUST connect the MAGMA expansion chassis to your computer BEFORE installing the MAGMA CardBus Driver.

MAGMA CardBus Drivers are required for Windows 2000. Follow the Step-by-Step Instructions included in Chapter Two: Quick Start Guide prior to installing the MAGMA CardBus Driver. It is important to apply power to the expansion chassis first, and then apply power to your computer.

WARNING

You must be logged in as ‘System Administrator’ while installing the MAGMA expansion chassis. You must remain logged in as ‘System Administrator’ until installation Is complete.

The first time your system boots￿6ORWup,6HULHVwith 8VHUthe ￿expansionV0DQXDOchassis￿￿ connected, the following System Settings Change Window will appear: