Magma CB1F manual Verify Installation

0$*0$

You should now Shut down the computer. This means, Turn off your computer completely.

After you have Shut down completely, it’s time to power-up again. The following System Settings Change Window will appear.

Click . Your computer will reboot.

As your system comes up, if PCI cards are installed in the expansion chassis, you may be prompted to load or locate drivers. Follow the instructions you see on the screen and install the drivers just as you would on a desktop computer. (You should refer to the procedures for installing drivers that was included with the third-party PCI device(s) you are installing) If prompted to reboot, do so.

Verify Installation

Go to ·Start ￿Settings ￿Control Panel ￿System ￿Device Manager (make sure ‘View device￿6ORWby connection’6HULHV8VHUis￿Vchosen)0DQXDO￿Open￿￿ ACP (BIOS) ￿Open PCI Bus￿Click the ‘+’ sign several times until your reach the DEC Bridge 21150 PCI to PCI Bridge. Under this entry you should see any hardware that is installed in the expansion chassis. (In the following example, there is an Adaptec AHA-2940U2U2W PCI SCSI Controller installed in the expansion system.)