Magma CB1F manual Verify Installation

0$*0$

You should now Turn off computer. This means, Shut down your computer completely.

After you have Turned off computer completely, it’s time to power-up again. The following System Settings Change Window will appear.

Click . Your computer will reboot.

As your system comes up, if PCI cards are installed in the expansion chassis, you may be prompted to load or locate drivers. Follow the instructions you see on the screen and install the drivers just as you would on a desktop computer. (You should refer to the procedures for installing drivers that was included with the third-party PCI device(s) you are installing) If prompted to reboot, do so.

Verify Installation

Go to ·Start ￿Control Panel ￿Printers and Other Hardware System ￿Hardware ￿Device Manager (make sure ‘View device by connection’ is chosen) ￿ACPI ￿Microsoft ACPI-Compliant System ￿ PCI Bus ￿Click the ‘+’ sign several times until your reach the DEC Bridge 21150 PCI to PCI Bridge. Under this entry you should see any hardware that is installed in the￿expansion6ORW6HULHVchassis8VHU￿V. 0DQXDO(In the following￿￿ example, there is an ATTO PCI SCSI Controller [LSI Logic 8950U…] installed in the expansion system.)