6 Hooking Up the TV/VCR
ANT.
ANT.
IN
OUT
ANT.
ANT.
Connect an RF coaxial cable
(75-ohm,not supplied) to the
OUT Jack on the Cable
Box/Satellite Receiver and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable TV signal or an
antenna to the ANT(enna) Jack.
1Hook up your TV/VCR using one of the connections shown.
ANT.
ANT.
Rod Antenna
(not supplied)
Connect the Cable TV or Satellite signal to the
IN Jack on the Cable Box/Satellite Receiver.
RF coaxial cable
(not supplied)
AHooking Up Your
TV/VCR With a Cable
TV Signal or Outdoor
Antenna
BHooking Up Your
TV/VCR With a Cable
Box/Satellite Receiver
To view any channel,set the
TV/VCR to the Cable
Box/Satellite Receiver output
channel (channel 03 or 04).
Then,select channels at the
Cable Box/Satellite Receiver.
CHooking Up Your
TV/VCR With an Indoor
Antenna
To install a rod antenna (not
supplied),push the stem of
the antenna into the antenna
hole on the rear of the
TV/VCR.Connect the antenna
wire to the ANT(enna) Jack
on the rear of the TV/VCR as
shown.Extend the antenna
and adjust its length,direction,
and angle for the clearest pic-
ture.