68
5Confirm with OK.
aThe following message appears on the screen: 'Please enter
channel number'
bThe channel number of the TV channel has not yet been assigned
Guide. Using C,Dor the number buttons 0..9on the remote
control, select the corresponding Guide channel number (name) of
the TV channel and confirm with OK .
aThe following message appears on the screen: 'PlusCode
number wrong'
bThe entered PlusCode number is incorrect. Correct your entry or
cancel using the SYSTEM-MENU button.
bCheck the time/date (see chapter 'Initial installation', section 'Setting
the time and date').
aThe following message appears on the screen: 'Date does not
match Mon-Fri'
bA daily recording was entered for the wrong day. Daily programming
can only be used for recordings to be made from Mondayto Friday. Problem
Timer
VCRPlus+ system
Date
01/22
Ch.
001
Start
08:30AM
End
10:00PM
Rec
Mode
HQ
Tostore
PressOK
6The data appears after confirmation. You can go back to change
the data. Select the field with Cor D. Change the information
with A,Bor the number buttons 0..9 .
Changing recording mode in the 'Rec Mode' input field
Select the 'Rec Mode' input field using C. Using B,Aselect the
recording mode 'HQ,SP+,EP,EP+'. Tip
7If all information is correct, press the OKbutton. The
programming information is stored in a TIMER block.
8To end, press TIMER.
9Insert a recordable disc in the Recorder.
10 Switch off the Recorder with STANDBY m.
The programmed recording will only function properly when the
DVD recorder has been switched off using the
STANDBYmbutton.
If any of the TIMER blocks are in use and the recordings are set ot occur, 's' will light up on
the display.
Programming a recording (TIMER)