ADC SG-1 user manual Second Level Commands June 30, Ethernet mode

Chapter 7: Second Level Commands June 30, 2006

<ethernet mode>

The operating mode of the interface to be configured (see Table 7-2).

(mtu)

The maximum transmission unit. Select either:

•1500 (default)

•1544

Example 1

Host(config)# interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500 interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500

Note: The system should refuse to assign an address to an Ethernet interface which is in the subnet of the other Ethernet interface and indicates the reason.

Example 2

Host(config)# interface ethernet 0\2 192.168.3.5. 255.255.255.0 Operation Error:

ethernet address is not valid

Note: The system should ignore the interface ethernet command if the system is in Ethernet redundancy mode. It will indicate a command failure to the system log and to the user interface (telnet).

Table 7-1. Configure Ethernet Ports

Card Type	Slot\Port	Slot\Port 2
Gigabit Front I/O	0\1
Gigabit Rear I/O	0\2	0\3
Gigabit Front (PMC) I/O	1\1	1\2

7-4 SG1-UM-8500-03