Chapter 7: Second Level Commands

June 30, 2006

Using the no pppoa enable command

Host(Config)# no pppoa enable interface

The no pppoa enable interface command disables PPPoA negotiation for a specific interface in the system.

Usage

No pppoa enable interface <slot number>\<port number\[sub-interface number]>

For parameters see Table 7-6.

Using the interface atm command

Host(config)# interface atm

The interface atm command defines the atm interfaces in the system.

The command is accessible at the "configure terminal" menu.

The command is only applicable with the SCC-ATM155 card.

When MTU is configured to 1500, the write terminal command should not be used.

IP address and loopback are not enabled for the PPP interface type.

The routed type interface does not support unnumbered links.

Usage

interface atm <slot>\<port number>\<sub-interface number> [type <ppp point-to-mul- tipoint

routed point-to-point<ip <ip address> <mask> >

routed-bridge<point-to-point> <ip <ip address> <mask> > loopback <loopback inter- face number>

routed-bridge-ppp<point-to-point> <ip [ip address> <mask> > loopback <loopback interface number>

]

[mtu <1500 1544>]

7-18

SG1-UM-8500-03

Page 98
Image 98
ADC SG-1 user manual HostConfig# no pppoa enable interface, Using the interface atm command, Hostconfig# interface atm