SG1-UM-8500-03 A-1
A
Appendix

SG-1 VENDOR-SPECIFIC ATTRIBUTES

This appendix describes the vendor-specific attributes related to SG-1 EDS architecture.
OVERVIEW
The vendor-specific attributes are based on RFC-2865 RADIUS recommendation. The first 4 octets are the vendor
id (supported vendor ID 2454, 2014). The next two octets are the vendor-type and length as recommended in the
RFC.
The attributes are split into the following groups:
• User
•DHCP
• protocol
•service
• route
• vpdn
•qos
•DNS
Vendor-Specific Attributes Table
When the system sends a vendor-specific attribute to the radius, it sets the vendor type with the attribute internal
number, as specified below in the vendor-specific attribute list (Table A-1).
Table A-1. Vendor-Specific Attribute List
Num Attribute Name Attribute
Group
Attribute
Value (1 byte
which takes
value of
1 to 255) First
Introduced Description
1 accounting user 10 V5.0 Allows defining the session
accounting operation mode and
methodology.
2 orig-name user 12 V5.0 Contains the original user name as
received during PPP negotiation.
3 auth-type user 13 V5.0 Contains the authentication type of
the Access Request message. It
provides the RADIUS with additional
information regarding the purpose of
the authentication.
4 action user 14 V5.0 Defines the action that should be
taken by the system.
5 SSC-host user 15 V5.0 Contains the SSC (Service
Selection Center) host IP address at
which the user activated the service.