ADC SG-1 user manual Using the pppoa enable command, Hostconfig# pppoa enable interface

June 30, 2006 Chapter 7: Second Level Commands

[loopback]

Places a logical loopback on the bridge-route interface.

<loopback number>

Numeric value assigned to the bridge-route loopback.

[mtu]

Used to set the interface's Maximum Transmission Unit (MTU) (valid values are 1500 or 1544). Example(s)

Host(config)# interface atm 2 \ 1 \ 1 type bridge-route point-to-point ip 192.168.10.1 255.255.255.0 mtu 1544

Added item

Host(config)#

Using the pppoa enable command

Host(config)# pppoa enable interface

This command enables PPPoA negotiation for a specific interface within the system.

Usage

pppoa enable interface <slot number>\<port number\[sub-interface number]>

Before enabling PPPoA, you must configure the correct port and the ATM interface.

Parameter(s)

Table 7-5. pppoa enable interface parameters

Parameter	Description	Legal values/range
<slot>	Slot number.	1 - 2
<port number>	Physical port number.	1 - 2
<sub-interface number>	Sub-interface number.	1- 2000

Example(s)

Host(config)# pppoa enable interface 0 \ 1

SG1-UM-8500-03 7-17