ADC SG-1 user manual Hostconfig# interface

Chapter 7: Second Level Commands June 30, 2006

<protect port>

The port number to be designated as the protect port (valid value = 1 or 2).

[SFBER (value)]

Signal Fail Bit Error Rate Threshold. Valid values = 3 to 12, Default = 3.

[SDBER (value)]

Signal Degrade Bit Error Rate Threshold. Valid values = 5 to 12, Default = 5.

Example(s)

Host(config)# port sonet redundancy-enable 2 \ 1 \ 2 \ 2 SFBER 3 SDBER 5 Updated item

Host(config)#

Configuring OC3 interfaces

Host(config)# interface

Usage

interface atm <slot> \ <port> <sub-interface> [type <ppp point-to - multipoint<routed point-to-point> ip <ip address> <mask><bridge-route point-to- point>(ip <ip address><mask>loopback <loopback number>)mtu <(15001544)>]

Parameter(s)

<slot>

The value 2 is required to select the SONET/SDH interface.

<port>

Use value 1 or 2 to select port 1 or 2.

<sub-interface>

A logical interface number from 1 to 2000.

[type <ppp point-to-multipoint>]

The ppp represents PPP termination.

[type <routed point-to-point> ip <ip address><mask>]

The routed parameter implies routing capability only.

[type <bridge-route point-to-point>]

The bridge-route parameter implies bridge and routing capabilities.

<ip address>

IP address for the interface to be configured.

<mask>

Valid mask for the associated IP address.

7-16 SG1-UM-8500-03