Rerecording (Tape Duplication) 33
1.Audio cables from AUDIO OUT Jacks of VCR 1 to AUDIO IN Jacks of VCR 2
VCR 1 | VCR 2 - Recording VCR | |
Playing VCR | ||
|
2.Video cable from VIDEO OUT Jack of VCR 1 to VIDEO IN Jack of VCR 2
1
Make the connections shown above.
2
VCR 1 will play your tape. Insert a prerecorded tape in VCR
1.If the tape does not have a record tab, playback begins. If this hap- pens, press the STOP/EJECT button on VCR 1 once.
3.RF coaxial cable from the OUT jack of
VCR 2 to the TV’s ANTENNA IN Jack
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. Make sure the record tab is intact (details are on page five). Make sure the VCR 2 power is on and VCR 2 is in VCR position. (The VCR/TV light will appear. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 3 or 4, whichever channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the Number but- tons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at right.)
6
Point the remote control at VCR 2. Use the SPEED button to select SP or SLP.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR button on VCR 2 at the same time.
8
To stop recording, press the STOP/EJECT button on VCR 2 once, then stop the tape on VCR 1.
Helpful Hints
•If you use the AUDIO and VIDEO IN jacks on the back of VCR 2, press Number buttons 0, 0, 1 at step 5. LineIn Rear (L1) will appear on the screen.
•If you use the AUDIO and VIDEO In jacks on the front of VCR 2, press Number buttons 0, 0, 2 at step 5. LineIn Front (L2) will appear on the screen.
•Unauthorized recording of copyright- ed television programs, video tapes, or other materials may infringe on the rights of copyright owners and violate copyright laws.
•If a program has copyright protection, it may not record clearly.
•Audio and video cables are not sup- plied.
•The illustration uses two VCRs just like yours. Different VCRs may oper- ate differently.
•When the VCR is in Line Input mode (L1 or L2), the screen will be blue.
