Makita manual Mounting Of Protector, For EM2650UH, For EM2650LH

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/ protector combinations as indicated in the table must be used.

For EM2650UH

–In use of the metal blade, fix the protector (3) to the clamp (2) with two bolts M6 x 30 (1).

NOTE: Tighten the right and left bolts evenly so that the gap between the clamp

(2) and the protector (3) will be constant.

Otherwise, the protector sometimes may not function as specified.

–In cases where the nylon cord cutter is to be used, be sure to mount the protector extension (4) onto the metal blade protector (3).

–Mount the protector extension (4) by sliding it into place from the flank of the metal blade protector (3) as shown.

–Remove tape adhered to cutter, which cuts nylon cord, on protector extension

(4).

CAUTION: Be sure to push in protector extension (4) until it is fully inserted. Take care not to injure yourself on the cutter for cutting the nylon cord.

–To remove the protector extension (4), apply a hex wrench into the notch on the metal blade protector (3), push it in and meanwhile slide the protector extension (4).

For EM2650LH

–Install the clamp (3) on the shaft so that the projection of the clamp (3) is inserted into the opening between the gear case (1) and the shaft. Secure the protector (4) with the installation bolts M6 x 30 (2).

(2)

(1)

(3)

(3)

(4)

Hex wrench

(2)

(1)

(4)

(3)

11