Makita EM2650UH, EM2650LH manual Procedure, Interval

(2)Air Induction System

(i)Air cleaner plate (including choke system)

(ii)Air cleaner cover

(iii)Air cleaner element

(3)Ignition System

(i)Spark Plugs.

(ii)Magneto or electronic ignition system.

(iii)Spark advance/retard system.

(4)Miscellaneous Items Used in Above Systems

(i)Hoses, Sealing gaskets, belts, connectors, and assemblies.

Makita USA, Inc will furnish with each new engine written instructions for the maintenance and use of the engine by the owner.

(e)MAINTENANCE STATEMENTS

It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2007 and later Owner’s Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. Makita USA, Inc will not deny a warranty claim solely because you have no record of maintenance; however, Makita USA, Inc may deny a warranty claim if your failure to perform required maintenance resulted in the failure of warranted part. The proof, which you maintain, should be given to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance described below based on the procedures specified in the 2007 and later Owner’s Manual. The scheduled maintenance below is based on the normal engine-operating schedule.

	PROCEDURE	INTERVAL
1)	Clean engine and check bolts and nuts. Retighten if	: Every 8 hours (daily)
	necessary.
2)	Check and refill engine oil (4 stroke engine only)	: Every 8 hours (refill daily up to upper limit)
3)	Change engine oil (4 stroke engine only)	: Initial 20 hours and every 50 hours afterward
4)	Check clogging of cooling air passage and cylinder	: Every 8 hours (daily)
	fins. Remove and clean if necessary.

5)Clean air cleaner.

6)Check spark plug. Clean and adjust if necessary.

7)Check muffler exhaust outlet (or port). Clean if necessary.

:Every 8 hours (daily)

:Every 8 hours (daily)

:Every 50 hours (monthly)

8)Check fuel filter. If clogged, replace with new one.

9)Adjust valve clearance, if applicable (4 stroke engine only).

:Every 50 hours (monthly)

:Every 200 hours (yearly)

10)	Replace fuel lines.	: Every 200 hours (yearly)
11) Clean and inspect the complete engine. Replace		: Every 200 hours
	any damaged or worn out parts.
12)	Replace packings and gaskets with new ones.	: Every reassembling

27