Makita EM4351UH Stop switch section, Fuel tube section, Checking Stop Switch, Fuel Tube Routing

P 16/ 22

Repair

[4]DISASSEMBLY/ ASSEMBLY

[4]-11.Stop switch section

CHECKING STOP SWITCH

Fig. 70

Check the continuity between the bullet terminals on the two lead wires extending from Control lever with a circuit tester. (Fig. 70)

If Stop switch functions properly, there will be no continuity with the switch ON and there will be continuity with the switch OFF.

[4]-12.Fuel tube section

FUEL TUBE ROUTING

Set Tube complete* in place as shown in Fig. 71.

•Connect Tube 3-260 to Carburetor and Gasoline filter with Hose clamp.

•Connect Tube 3-150 to the long pipe of Primer pump.

•Connect Tube 3-120 to the short pipe of Primer pump.

Also refer to Fig. 72.

(3)Put Coil spring 8 and Clamp on Tube 3-150. (Fig. 71)

(4)Route Tube 3-150 as drawn in Fig. 72.

Route Tube 3-120 between Tube 3-150 and Cleaner plate assembly. (Fig. 73)

Fig. 71

Holders of	Tube 3-260 (black)			(to Carburetor)
Cleaner plate assembly	Breather (to intake air into Tank)				Tube complete		long pipe of
		Hose clamp
						Breather	Primer pump
		Gasoline filter		Tube 3-260
				(black)
		Clamp
	Coil			Tube
	spring 8			3-150
				(blue)
						Grommet
						short pipe of Primer pump
		Tube 3-150 (blue)				to connect Tube 3-120
						(Refer to Figs. 68 and 69.)
Fuel tank		(to intake air into Tank)
Fig. 72				Fig. 73
Nipple of Carburetor			Tube 3-260		Tube 3-120		Tube 3-150 (blue)
Tube 3-120			(black)		(blue)
				Tube 3-150
(blue)
				(blue)

Spiral tube		Fuel tank
6-100
	Spiral tube 6-80	Pipe	Breather