P 14/ 26
Repair
[18]Angle adjustment of guide fence
1.Provisionally tighten a M6x25 hex bolt into screw hole A on the operator's left side of guide fence as Fig. 17.
2.While checking the angle of guide rule to saw blade using 90 degrees set square (No.1R208), adjust the guide fence by moving its right end until the angle sets at 90 degrees.
3.After completion of squaring adjustment, securely tighten three M6x25 hex bolts in order of C, B, A.
Fig. 17
| Hex bolt M6x25 |
| |
A | B | C | |
Screw hole A is smaller |
|
| |
than Screw hole B/C. |
| Move this side. | |
90 degrees set square | |||
| |||
(No.1R208) |
| ||
Saw blade
Operator's position
[19] Disassembling laser section (exclusively for LS0714FL/ LS0714L)
1.Remove lock lever from rod 8 before disassembling laser section. Refer to the chapter < 6 > "Assembling safety lock mechanism".
2.After removing thumb screw M5x24, remove top cover by taking off tapping screw bind CT4x20. See Fig.
3.Take off laser line label which adheres on blade case, and remove shoulder screw M5 with which laser section is secured on blade case.
Fig.
Tapping screw bind CT4x20
Flat washer 5
Thumb screw M5x24
Shoulder screw M5 
Top cover
Laser line label 
Tapping screw bind CT4x20
4.Remove lead cover holder by unscrewing tapping screw bind CT4x20. Then, lead coverA and lead cover B can be removed from blade case. See Fig.
5.Disconnect socket unit of laser circuit from connector of lead unit.
6.Then, laser section can be removed from blade case.
Fig.
| Lead cover holder | Tapping screw bind CT4x20 |
|
| |
| Lead cover B | Lead cover A |
|
| |
Connector of |
| Laser section |
lead unit |
| (Laser circuit, block B, |
|
| block C, etc.) |
Socket unit of 
laser circuit 
< Caution >
Be careful not to touch the lens for laser beam. The laser beam irradiated through the smeared lens becomes indistinct.
