Makita LS0714F Repair Angle adjustment of saw blade, Adjustment for max. cutting capacity

P 13/ 26

Repair

[16] Angle adjustment of saw blade

1.Adjust the angle of saw blade at 90° against turn base using 90 degrees set square (Makita Part No.1R208). See Fig. 15-1. While keeping this condition, fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm. See Fig. 15-2.

2.As for 45° degrees adjusting, use 45 degrees set square as Fig. 15-3.

After that the fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm as Fig. 15-4.

Fig. 15-1

1R208 : 90 degrees set square

90°

Fig. 15-3

1R207 : 45 degrees set square

45°

[17] Adjustment for max. cutting capacity

Fig. 15-2

Arm

90°

0 degrees bevel angle adjusting bolt (Hex bolt M6x16)

Fig. 15-4

Arm

45°

45 degrees bevel angle adjusting bolt (Hex bolt M6x16)

Do the following steps to obtain the max. cutting capacity.

1.Pull the motor unit to your side until it stops.

2.Lower the motor unit until it stops.

3.And then adjust the Ø190mm saw blade so that it comes to the position shown in Fig. 16.

Note: The saw blade must not contact kerf boards and base, when the motor unit is in the lowest position. 4. Tighten hex bolt M6x16 using socket wrench 10.

Fig. 16

Socket wrench 10

(Standard equipment)

Hex bolt M6x16

ø190mm saw blade

Kerf board