Makita RBC411 instruction manual Mounting of cutter blade

Mounting of cutter blade

–Insert the hex wrench through the hole in the gear case and rotate the receiver washer (4) until it is locked with the hex wrench.

–Loosen the nut (1) (left-hand thread) with the socket wrench and remove the nut (1), cup (2), and clamp washer (3).

Mounting of cutter blade

With the hex wrench still in place.

–Mount the cutter blade onto the shaft so that the guide of the receiver washer

(4)fits in the arbor hole in the cutter blade. Install the clamp washer (3), cup (2), and secure the cutter blade with the nut (1).

[Tightening torque: 13 - 23 N•m]

NOTE: Always wear gloves when handling the cutter blade.

NOTE: The cutter blade-fastening nut (with coned disc spring) is a consumable part.

If there appears any wear or deformation on the coned disc spring washer, replace the nut.

Make sure that the blade is the left way up.

Loosen

Tighten

Hex Wrench

11