4
– Start the brush cutter only in accordance with the instructions.
Do not use any other methods for starting the engine!
– Use the brush cutter and t he tools only for such applications as specified.
– Only start the brush cutter engine, after the entire assembly is done. Operation
of the device is only permitted after all the appropriate accessories are
attached!
– Before starting make sure that the cutting tool has no contact with hard objects
such as branches, stones etc. as the cutting tool will revolve when starting.
– The engine is to be switched off immediately in case of any engine proble ms.
– Should the cutting tool hit stones o r other hard objects, immediately switch off
the engine and inspect the cutting tool.
– Inspect the cutting tool at short regular intervals for damage (detection o f
hairline cracks by means of tapping-noise test).
– Operate the bru sh cutter only with the shoulder strap attached which is to be
suitably adjusted before putting the brush cutter into operation. It is essential
to adjust the shoulder strap according to the user's size to prevent fatigue
occurring during use. Never hold the cutter with one hand during use.
– During operation always hold the brush cutter with both hands.
Always ensure a safe footing.
– Operate the bru sh cutter in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (risk of gas
poisoning). Carbon monoxide is an odorless gas.
– Switch off the engine when resting and when leaving the brush cutter
unattended, and place it in a safe location to prevent danger to others or
damage to the machine.
– Never put the hot brush cu tter onto dry grass or onto any combustible
materials.
– The cutting t ool has to be equipped with it's appropriate guard.
Never run the cutter without this guard!
– All protective installations and guards supplied with the machine must be used
during operation.
– Never operate the engine with faulty exhaust muffler.
– Shut off the engine during transport.
– During transpor t over long distances the tool protection included with the
equipment must always be used.
– Ensure safe position of the brush cutter during car transportation to avoid fuel
leakage.
– When dispatching the brush cutter, ensure that the fuel tank is completely
empty.
– W hen unloading the Brush Cutter from the truck, never drop the Engine to the
ground or this may severely damage the fuel tank.
– Except in case of emergency, never drop or cast the Brush Cutter to the
ground or this may severely damage the Brush Cutter.
– Remember to lift the entire equipment from the ground when moving the
equipment. Dragging the fuel tank is highly dangerous and will cause damage
and leakage of fuel, possibly causing fire.
• Resting
• Transport
• Refuelling
• Maintenance
• Tool Replacement