Marantz MV5100 manual Connecting the Controller, Use an RF coaxial cable to

MV5100 27-84 7/21/00 10:59 AM Page 50

50 Connecting the Controller

If you are using a Cable Box/DBS, connect the Controller to your VCR.The Controller will automatically select channels at the Cable Box/DBS during a timer recording. Leave your Cable Box/DBS turned on dur- ing a timer recording.

1

Connect the Cable Box/DBS to the VCR as shown below. For more information, please read page 8.

Or, refer to the owner’s manual of your Cable Box/DBS.

Connect the Cable signal to the IN Jack of the Cable Box/DBS.

Cable Box/DBS	Controller		Connect the Controller
			to the CABLE BOX Jack
			on the back of the VCR.
		LP 20917-003	Back of TV (example)
(MONO)	OUT IN	ANTENNA IN
VIDEO		VHF/UHF
L
AUDIO	S VIDEOCABLE BOX
R		CH3 CH4
		TV OUT	LP 20917-003
OUT IN

VHF/UHF
75V
ANT	/
CABLE

Use an RF coaxial cable to	TV OUT
connect the OUT Jack on
the Cable Box/DBS to the
ANTENNA IN Jack on	Use a second RF coaxial cable to
the back of the VCR.
	connect the TV OUT Jack on the
	VCR to the TV's ANTENNA IN Jack

2

Connect the Controller to the CABLE BOX Jack on the back of the VCR as shown above.

3

Attach the Controller to the top of the VCR using the supplied adhesive. Make sure the Controller’s transmitter (the light on the top of the Controller) is pointed toward the Cable Box/DBS remote sensor.

Cable Box/DBS

Controller

POWER

S-VHS ET VCR/TV

OPEN A/V FRONT CONNECTORS

MENU

AUDIO

DUBBING

OK/STATUS

SUPER VHS ET

VCR

REC/OTR

CHANNEL

HI-FI STEREO VIDEO CASSETTE RECORDER MV5100

STOP/EJECT

PAUSE/STILL PLAY

4

If you are using a Cable Box, follow the steps on pages 51-52 to make the Controller change channels at the Cable Box during timer recordings.

If you are using a DBS, follow the steps on pages 53-54 to make the Controller change chan- nels at the DBS during timer recordings.