Marantz MV5100 manual Setting the Controller to Operate a DBS cont’d, 7Wait for a few seconds

MV5100 27-84 7/21/00 10:59 AM Page 54

54 Setting the Controller to Operate a DBS (cont’d)

6

Press the PLAY 8 or STOP 9 button to set the two-digit code for your DBS (see list below), then press the OK/STATUS button.

7Wait for a few seconds.

SAT/

CBL/DBS TV VCR

SELECT CODE NUMBER OF YOUR DBS RECEIVER

40

DID DBS RECEIVER

CHANGE TO CHANNEL 205?

A YES
NO
SELECT: 89	CONFIRM:OK
END: MENU

	DBS CODES
MAGNAVOX DBS	.........................................................42, 43
RCA DBS	40
SONY DBS	41	6-8
7

Wait for a few seconds.

•If the DBS changes to channel 205, go to step 8.

•If the DBS doesn’t change to channel 205, press the PLAY 8 or STOP 9 button to select NO, then press the OK/STATUS but- ton. Repeat steps 6-7, using a different code for your brand (if available).

•If the DBS does not respond to any of the codes, press the MENU button to remove the menu. DBS RECEIVER CONTROL IS OFF will appear on the screen briefly.

VCR/TV POWER SMARTPICTURE

QUICK PROGRAMMING

1– +* + 2 ABC + 3 DEF

START		STOP	DATE
4 GHI - 5 JKL - 6 MNO
VPS/PDC		DAILY	WEEKLY
7PQRS		8 TUV	9WXYZ
SPEED		DBS/SAT
ALT		0	CLEAR
-	STILL/SLOW			+
	..........		..........
REW				FF
		PLAY

STOP

VOL OK/STATUS CH

MENU

TIMER

TURBO AUDIO/ SKIP TAPE

TIMER MUTE SEARCH MANAGER

JOG/SHTL REC /OTR

8 REV FWD

Press the PLAY 8 or STOP 9 button to select YES, then press the OK/STATUS button. “DBS RECEIVER CONTROL IS ON” will appear for five seconds. “AS A RESULT AUTO CLOCK WILL BE TURNED OFF” may appear on the screen also.

Helpful Hint

• If your DBS does not respond to the code at step 7, the Controller will not change channels at the DBS during a timer recording. In this case, you must select the channel to be recorded at the DBS before a timer recording begins. Enter the DBS output channel (03 or 04) at step 3 on page 40. Leave the DBS on for the timer recording. Details are on page eight.