ENGLISH |
| BEFORE USE |
|
| |
|
| This section must be read before any connection is |
|
| made to the mains supply. |
|
|
|
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the household power and safety requirements that exist in your area.
SR4002/SR5002 can be powered by 120V AC only.
COPYRIGHT
Recording and playback of any material may require consent. For further information refer to the following:
—Copyright Act 1956
—Dramatic and Musical Performers Act 1958
—Performers Protection Acts 1963 and 1972
—Any subsequent statutory enactments and orders
DO NOT LOCATE IN THE FOLLOWING PLACES
To ensure
KEEP OBJECTS OFF
Keep objects off the unit. Blocking the vent can result in accident and damage.
DO NOT TOUCH HOT SPOTS DURING AND
IMMEDIATELY AFTER USE
During and immediately after use, the unit is hot in areas other than the controls and rear panel connection jacks. Do not touch hot spots and especially the top panel. Contact with hot areas can cause burns.
OPERATION OF REMOTE CONTROLLER
REMOTE CONTROL
Operate the remote controller within a distance of approx. 5m from the infrared receptor window on the front of the unit.
LOADING BATTERIES
Before using the remote controller for the first time, load the batteries in the remote controller. The batteries provided are used to verify the operations of the remote controller only.
1. Remove the battery cover.
2. Load the two new size “AAA” batteries inside the battery compartment while taking care to align their polarities correctly with the polarity markings (
with (
and
with
).
CAUTIONS ON BATTERIES
•Use “AAA” type batteries in this remote controller.
•We recommend that you use alkali batteries.
•If the remote controller does not operate from close to the unit, replace the batteries with new ones, even if less then a year has passed.
•The included battery is only for verifying operation. Replace it with a new battery as soon as possible.
•When inserting the batteries, be careful to do so in the proper direction, following the + and - marks in the remote controller’s battery compartment.
•To prevent damage or battery fluid leakage:
-Do not use a new battery with an old one.
-Do not use two different types of batteries.
-Do not
•Remove the batteries when not planning to use the remote controller for a long period of time.
•If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries.
•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.
•Exposed to direct sunlight.
•Near to sources of heat such as heaters.
•Highly humid or poorly ventilated.
•Dusty.
•Subjected to mechanical vibrations.
•On wobbly, inclined or otherwise unstable surfaces
•Radiated heat is blocked such as in cramped audio racks.
To ensure proper heat radiation, ensure the below clearance from walls and other equipment.
| 8 ins. (0.2 m) |
8 ins. (0.2 m) | 8 ins. (0.2 m) |
8 ins. (0.2 m)
60°
SR4002/SR5002
Remote controller
3. Close the battery cover until it clicks shut.
Caution:
•Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the player’s infrared receptor window. Otherwise,
the operation of the remote controller may be disabled.
•Bear in mind that operating the remote controller may cause other devices operated by infrared rays to be operated by mistake.
•The remote controller cannot be operated if the space between the controller and the player’s infrared receptor window is obstructed.
•Do not place any objects on top of the remote controller.
Doing so may cause one or more buttons to be held down which will cause the batteries to run down.
4
